In the second week, our group members seek advice from PhD Yuxuan Zeng and learn that how to make a design drawing by using Solid Works software.After hardworking, we complete the design three-view drawing of an LCR triggered 2-stage spark gap switch. In the following, I will show our drawing of spark gap switch.
 |
| These two pictures show the example of the spark gap switch. However, in our design, we use 3 AL slices rather than 2 AL slices. Top and bottom AL are the same but the middle AL has a little different. A PTFE stick would connect the 3 AL slices. |
 |
| Middle AL custom view |
 |
| Middle AL top view |
 |
| Middle AL front view |
 |
| It is the middle AL spin view. If we spin it along the central axis, we will get the overall view of the middle AL slice. |
 |
| Top and bottom AL custom view-1 |
 |
| Top and bottom al custom view-2 |
 |
| Top and bottom al front view |
 |
| Top and bottom al top view |
 |
| Top and bottom al bottom view |
 |
| Top and bottom al front view |
 |
| PTFE custom view |
 |
| PTFE front view |
 |
| PTFE isometric view |
 |
| PTFE top view |
没有评论:
发表评论